Sensor
Module
Remote
Motor
Resistor
Banana
Motor Driver
Display Board
Wireless
Component
Board
Robot
Connector
Wire
Wheel
ESC
Drone
Propeller
Display
Tester
Battery
Development Board
Solenoids and Electromagnets
Holder
Switch
Drill bit
3D
Memory
Cable
Raspberry Pi
Converter
Card Reader
Bluetooth
Adapter
Relay
IC
Transistor
Depeloment Kit
PCB
Arduino Board
Camera
Shield
Mosfet
Power Transistor
Microcontrollers
IC base
Trimmer
Iron
Charger
Programmer
Thermal Paste
None
3d Printer
ESP board
All

CNC Shield

Version 3.00 4-Axis support (X, Y, Z , A-Can duplicate X,Y,Z or do a full 4th axis with custom firmware using pins D12 and D13) 2 x End stops for each axis (6 in total - each axis pair shared by same IO pin) Spindle enable and direction connection Coolant enable connection Uses GRBL as control software Power supply: DC 12-36V (only the DRV8825 drivers can handle up to 36V so if using A4988 do not exceed 24V) Uses removable stepper drivers (DRV8825 or A4988) Stepper Motors can be connected with 4 pin dupont/molex connectors Jumpers to set Micro-Stepping

CNC Shield

PRODUCT ID/SKU : D09-01

Rs. 550.00

The CNC Shield was designed by Protoneer.co.nz to take advantage of the demand for a low-cost controller solution for DIY CNC machines. It was designed to be 100% compatible with Grbl, the Opensource G-Code interpreter, and fit onto the popular Arduino Uno. The CNC Shield can be used to control a number of different types of CNC machines, including CNC milling machines, laser engraving/cutting machines, drawing machines, 3D printers or any project that needs precision control of stepper motors.
Category: Shield
Home About Us Products Contact Us
insta twitter fb yt
© Techkey 2021. All rights reserved.